Inter-Scan Code Delay - Honeywell Voyager 1200g User Manual
Single-line laser bar code scanner
Hide thumbs
Also See for Voyager 1200g:
- User manual (288 pages) ,
- Quick start manual (13 pages) ,
- User manual (238 pages)
Table of Contents
Advertisement
Default = Control + ASCII Mode Off.
Windows Mode Control + ASCII
Mode On
* Control + ASCII Mode Off
DOS Mode Control + ASCII Mode
On
Windows Mode Prefix/Suffix Off
Numeric Keypad Mode: Sends numeric characters as if entered from a numeric keypad. Default = Off.
Numeric Keypad Mode On
* Numeric Keypad Mode Off
Inter-Scan Code Delay
When your keyboard detects that any key is being pressed, released, or held down, the keyboard sends a packet of infor-
mation known as a "scan code" to your computer. This selection allows you to adjust the delay between scan codes. Set
the length (in milliseconds) for a delay by scanning the bar code below, then setting the delay (from 1-30) by scanning digits
from the
Programming
Chart, then scanning Save. Default = 0 (800 µs).
Inter-Scan Code Delay
2 - 20
Advertisement
Table of Contents
Troubleshooting
