Connecting With Rs485 - Honeywell Voyager 1200g User Manual

Connecting with RS485

A scanner or base can be connected for an IBM POS terminal interface.
1. Connect the appropriate interface cable to the device, then to the computer.
2. Make sure the cables are secured in the wireways in the bottom of the base and that the base sits flat on a horizontal
surface.
3. Turn the terminal/computer power back on. The scanner beeps.
4. Verify the scanner or base operation by scanning a bar code from the
scanner beeps once.
For further RS485 settings, refer to RS485, page 2-1.
1 - 4
Charge and
Communications
Base RS485
Connection:
Sample Symbols in the back of this manual. The