Object Detection Laser Timeout
You can set a timeout for the length of time the laser remains on and attempting to decode bar codes after an object is
detected. Set the length (in milliseconds) for a timeout by scanning the following bar code, then setting the timeout (from 1-
65535 milliseconds) by scanning digits from the
Object Detection Laser
Timeout In-Stand
Object Detection Distance
When the scanner is in the stand and you are using Object Detection Mode, you can set the distance range for detecting
objects. Short sets the scanner to detect objects approximately 5 inches (12.7cm) away from the nose. Long sets it to
detect objects approximately 10 inches (25.4cm) away. Default = Short In-Stand, Long Out-of-Stand.
* Short
In-Stand
Short
Out-of-Stand
Character Activation Mode
You may use a character sent from the host to trigger the scanner to begin scanning. When the activation character is received,
the scanner continues scanning until either the
received (see
Deactivation Character
acter activation, then use Activation Character (following) to select the character you will send from the host to start scanning.
Default = Off.
* Off
Programming
Character Activation Laser Timeout
on page 4-13), or a bar code is transmitted. Scan the following On bar code to use char-
Chart, then scanning Save. Default = 5000 ms.
(page 4-12), the deactivation character is
Object Detection Laser
Timeout Out-of-Stand
Long
In-Stand
* Long
Out-of-Stand
4 - 11