Network Statistics - Cisco 6901 Administration Manual

Chapter 6 Monitoring the Cisco Unified IP Phone Remotely
Table 6-2 Network Configuration Area Items (continued)
Item
CDP: PC Port
(Cisco Unified IP Phone
6911 only)
CDP: SW Port
SSH Access Enabled
EnergyWise Level
EnergyWise Domain
FIPS Mode Enabled
IP Addressing Mode
IP Preference Mode Control Indicates the IP address version that the phone uses during signaling with Cisco Unified
IPv6 Auto Configuration
IPv6 CAPF Server
DHCPv6
IPv6 Default Router 1
IPv6 Address
IPv6 Prefix Length
IPv6 TFTP Server

Network Statistics

The following network statistics hyperlinks on a phone's web page provide information about network
traffic on the phone. To display a network statistics area, access the web page for the phone as described
in the
•
Cisco Unified IP Phone 6901 and 6911 Administration Guide for Cisco Unified Communications Manager 8.6 (SCCP and SIP)
OL-24582-01
Description
Indicates whether CDP is supported on the PC port (default is enabled).
Enable CDP on the PC port when Cisco VT Advantage/Unified Video Advantage (CVTA) is
connected to the PC port. CVTA does not work without CDP interaction with the phone.
When CDP is disabled in Cisco Unified Communications Manager, a warning displays to
indicate that disabling CDP on the PC port prevents CVTA from working.
The current PC and switch port CDP values are shown on the Settings menu.
Indicates whether CDP is supported on the switch port (default is enabled).
Enable CDP on the switch port for VLAN assignment for the phone, power negotiation, QoS
management, and 802.1x security.
Enable CDP on the switch port when the phone is connected to a Cisco switch.
When CDP is disabled in Cisco Unified Communications Manager, a warning is presented,
indicating that CDP should be disabled on the switch port only if the phone is connected to a
non-Cisco switch.
The current PC and switch port CDP values are shown on the Settings menu.
Indicates whether the phone accepts or blocks the SSH connections.
Indicates the EnergyWise Level.
The EnergyWise domain that the phone is in.
Indicates whether the FIPS Mode parameter is enabled.
Displays the IP addressing mode that is available on the phone.
Communications Manager when both IPv4 and IPv6 are both available on the phone.
Displays whether the auto configuration is enabled or disabled on the phone.
Common Name (from the Cisco Unified Communications Manager Certificate) of the CAPF
used by the phone.
Dynamic Host Configuration Protocol (DHCP) automatically assigns IPv6 address to devices
when you connect them to the network. Cisco Unified IP Phones enable DHCP by default.
Default router used by the phone (Default Router 1).
IPv6 address of the phone. The IPv6 address is a 128 bit address.
Subnet prefix length that is used by the phone. The subnet prefix length is a decimal value
from 1-128, that specifies the portion of the IPv6 address that comprises the subnet.
Indicates whether the phone is using the IPv6 Alternate TFTP server.
"Accessing the Web Page for a Phone" section on page
Ethernet Information—Displays information about Ethernet traffic.
this area.
Network Statistics
6-1.
Table 6-3 describes the items in
6-7