Cisco 6901 Administration Manual page 62

Accessing the Phone Configuration Settings
Table 4-2
Table 4-2
Action
Review or Set Network Settings 1
Review or Set TFTP Server
Enable or Disable DHCP
Enable or Disable 802.1X
Cisco Unified IP Phone 6901 and 6911 Administration Guide for Cisco Unified Communications Manager 8.6 (SCCP and SIP)
4-4
describes the various options in the IVR Configuration Menu.
Navigating the IVR Configuration Menu
IVR Code
2
3
4
Chapter 4 Configuring Settings on the Cisco Unified IP Phone
Navigating Notes
If DHCP is enabled, the IVR announces each network
parameter.
If DHCP is disabled, the IVR announces each network
parameter, pausing in between each parameter to allow
you to enter a new value.
1. IVR announces the IP Address. To change the IP
address for the phone, use the keypad to enter a
new IP address, followed by the #. To retain the
current IP address, press #.
Note To enter the dot ":" that separates each octet in
the IP address, press *.
IVR announces the subnet mask. To change the
2.
subnet mask use the keypad to enter a new IP
address, followed by the #. To retain the current
subnet mask, press #.
3. IVR announces the default gateway. To change the
default gateway, use the keypad to enter a new IP
address, followed by the #. To retain the current
default gateway, press #.
IVR announces the current TFTP setting.
To change the TFTP server, use the keypad to enter a
new address, followed by the #. To retain the current
TFTP server, press #.
To reset a TFTP server back to the TFTP server set by
the DHCP server from a manually configured TFTP
server, press *.
To enter the dot ":" that separates each octet in
Note
the IP address, press *.
Press 3 to toggle DHCP to enable or disable.
Press 4 to toggle 802.1X to enable or disable security.
OL-24582-01