Manager; Overview Of Configuring And Installing Cisco Unified Ip Phones; Configuring Cisco Unified Ip Phones In Cisco Unified Communications Manager; Checklist For Configuring The Cisco Unified Ip Phone 6901 And 6911 In Cisco Unified Communications Manager - Cisco 6901 Administration Manual

Overview of Configuring and Installing Cisco Unified IP Phones

Overview of Configuring and Installing Cisco Unified IP Phones
When deploying a new IP telephony system, system administrators and network administrators must
complete several initial configuration tasks to prepare the network for IP telephony service. For
information and a checklist for setting up and configuring a Cisco IP telephony network, go to the
System Configuration Overview
After you set up the IP telephony system and configure system-wide features in Cisco Unified
Communications Manager, you can add IP Phones to the system.
The following topics provide an overview of procedures for adding Cisco Unified IP Phones to your
network:
•
•
Configuring Cisco Unified IP Phones in Cisco Unified Communications

Manager

To add phones to the Cisco Unified Communications Manager database, you can use:
•
•
•
•
For more information about these choices, see the
Communications Manager Database" section on page
For general information about configuring phones in Cisco Unified Communications Manager, refer to
the following documentation:
•
•
•
Checklist for Configuring the Cisco Unified IP Phone 6901 and 6911 in Cisco Unified Communications
Manager
Table 1-8
IP Phone 6901 and 6911 in Cisco Unified Communications Manager Administration. The list presents a
suggested order to guide you through the phone configuration process. Some tasks are optional,
depending on your system and user needs. For detailed procedures and information, refer to the sources
in the list.
Cisco Unified IP Phone 6901 and 6911 Administration Guide for Cisco Unified Communications Manager 8.6 (SCCP and SIP)
1-18
Configuring Cisco Unified IP Phones in Cisco Unified Communications Manager, page 1-18
Installing Cisco Unified IP Phones, page 1-21
Autoregistration—Not supported if Cisco Unified Communications Manager is operating in mixed
mode.
Cisco Unified Communications Manager
Bulk Administration Tool (BAT)
BAT and the Tool for Auto-Registered Phones Support (TAPS)
Cisco Unified IP Phones, Cisco Unified Communications Manager System Guide
Cisco Unified IP Phone Configuration, Cisco Unified Communications Manager Administration
Guide
Autoregistration Configuration, Cisco Unified Communications Manager Administration Guide
provides an overview and checklist of configuration tasks for the Cisco Unified
Chapter 1
chapter in Cisco Unified Communications Manager System Guide.
"Adding Phones to the Cisco Unified
2-7.
An Overview of the Cisco Unified IP Phone
OL-24582-01