Cisco 6901 Administration Manual page 63

Chapter 4 Configuring Settings on the Cisco Unified IP Phone
Table 4-2
Action
Review or Set Ipv6 Network
Settings
Review or Set Ipv6 TFTP Server 6
Enable or Disable DHCPv6
Reset to factory settings
Cisco Unified IP Phone 6901 and 6911 Administration Guide for Cisco Unified Communications Manager 8.6 (SCCP and SIP)
OL-24582-01
Navigating the IVR Configuration Menu (continued)
IVR Code
5
7
0
Accessing the Phone Configuration Settings
Navigating Notes
If DHCPv6 is enabled, the IVR announces each
network parameter sequentially: IPv6 address, IPv6
prefix length, IPv6 subnet mask, and IPv6 default
gateway.
If DHCPv6 is disabled, the IVR announces each
network parameter, pausing in between each parameter
to allow you to enter a new value.
IVR announces the IPv6 Address. To change the
1.
IPv6 address for the phone, use the keypad to enter
a new IPv6 address, followed by the #. To retain
the current IPv6 address, press #.
To enter the dot ":" that separates each octet in
Note
the IPv6 address, press *.
2. IVR announces the subnet mask. To change the
subnet mask use the keypad to enter a new IPv6
address, followed by the #. To retain the current
subnet mask, press #.
IVR announces the default gateway. To change the
3.
default gateway, use the keypad to enter a new
IPv6 address, followed by the #. To retain the
current default gateway, press #.
IVR announces the current Ipv6 TFTP setting.
To change the IPv6 TFTP server, use the keypad to
enter a new IPv6 address, followed by the #. To retain
the current Ipv6 TFTP server, press #.
To reset a Ipv6 TFTP server back to the Ipv6 TFTP
server set by the DHCPv6 server from a manually
configured Ipv6 TFTP server, press *.
Note To enter the dot ":" that separates each octet in
the IPv6 address, press *.
Press 7 to toggle DHCPv6 to enable or disable.
Note All configuration settings change to the
default factory settings, and the phone resets.
It will take some time for the phone to
reregister. Select this option only when
needed.
4-5