Installing The Bracket - Cisco 6901 Administration Manual

Installing a Wall Mount for the Cisco Unified IP Phone 6911

Installing the Bracket

To install the phone on the wall, follow these steps:
Procedure
Step 1 Mount the wall bracket in the desired location
Ethernet jack, or you can run the Ethernet network cable to a jack nearby.
a.
b.
c.
d.
Cisco Unified IP Phone 6901 and 6911 Administration Guide for Cisco Unified Communications Manager 8.6 (SCCP and SIP)
E-8
Use the Level to ensure the wall bracket is level, then use a pencil to mark the screw holes.
Using a #2 Phillips-head screwdriver, carefully center the anchor over the pencil mark and press the
anchor into the wall to make markings on the wall.
Screw the anchor clockwise into the wall until it is seated flush.
Use the included screws and a #2 Phillips-head screwdriver to attach the wall bracket to the wall.
Appendix E Installing the Wall Mount for the Cisco Unified IP Phone 6901 and 6911
(Figure E-8). You can install the wall bracket over an
OL-24582-01