Terminal Length - D-Link DXS-3600 Series Reference Manual

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Command Default Level
Level: 1.
Usage Guideline
This is the Telnet client function and can be used to communicate with another device using the Telnet
feature. The Telnet software supports special Telnet commands in the form of Telnet sequences that map
generic terminal control functions to operating system-specific functions. To issue a special Telnet
command, enter the escape sequence and then a command character. The default escape sequence is
CTRL+_ (press and hold the CTRL and Shift keys and the underscore '_' key). The special Telnet
commands will be displayed as follows:
•
e – Exits the Telnet connection. Either an uppercase or lowercase letter 'e' can exit the Telnet
connection.
If another key is pressed, the terminal will return to the original active Telnet session.
Multiple Telnet sessions can be opened on the switch system and each open Telnet session can have its
own Telnet client software supported at the same time
Example
This example shows how to Telnet to the IP address 10.90.90.91 using the default port 23. The IP
address, 10.90.90.91 is the DXS-3600-32S management interface which allows a user to login.
Switch# telnet 10.90.90.91
Password required, but none set
Switch#
This example shows how to Telnet through port 23 to 10.90.90.91 and the connection failed. Try using
port 3500 instead to login into the management interface.
Switch#telnet 10.90.90.91
ERROR: Could not open a connection to host on server port 23.
Switch# telnet 10.90.90.91 3500
Password required, but none set
Switch#

5-18 terminal length

DXS-3600-32S Gigabit Ethernet Switch
Command Line Interface
Firmware: Build 2.00.012
Copyright(C) 2013 D-Link Corporation. All rights reserved.
DXS-3600-32S Gigabit Ethernet Switch
Command Line Interface
Firmware: Build 2.00.012
Copyright(C) 2013 D-Link Corporation. All rights reserved.
84