Show Dot1X Diagnostics - D-Link DXS-3600 Series Reference Manual

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Port Control
Tx Period
Supp Timeout
Server Timeout
Max-req
Forward PDU
Switch#

3-13 show dot1x diagnostics

This command is used to display IEEE 802.1X diagnostics. If no interface is specified, information about
all interfaces will be displayed.
show dot1x diagnostics [interface INTERFACE-ID [, | -]]
Parameters
interface INTERFACE-ID
,
-
Default
None.
Command Mode
User EXEC or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
This command can be used to display 802.1X diagnostics. Using this command without parameters will
display information about all interfaces. Otherwise, the diagnostics on the specified interface will be
displayed.
Example
This example shows how to display the dot1X diagnostics on Ethernet port 1/0/1.
Switch# show dot1x diagnostics interface eth1/0/1
eth1/0/1 dot1x diagnostic information are following:
EntersConnecting
EAP-LogoffsWhileConnecting
EntersAuthenticating
SuccessesWhileAuthenticating
TimeoutsWhileAuthenticating
: Auto
: 30 sec
: 30 sec
: 30 sec
: 2 times
: Disabled
(Optional) Specifies to display the dot1x diagnostics on the specified
interface or range of interfaces. If not specified, information about all
interfaces will be displayed.
(Optional) Specifies a series of interfaces, or separate a range of
interfaces from a previous range. No space is allowed before and after
the comma.
(Optional) Specifies a range of interfaces. No space is allowed before
and after the hyphen.
: 20
: 0
: 0
: 0
: 0
38