Cfm Linktrace - D-Link DXS-3600 Series Reference Manual

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Usage Guideline
This command is used to start or stop the CFM management lock. This command will result in the MEP to
send LCK PDUs to a client level MEP. Verify the status of the CFM management lock action by entering
the show cfm mep command. The LCK Action item in the show cfm mep command will indicate the
status of the CFM management lock action is start or stop.
Example
This example shows how to start the management lock.
Switch# cfm lck start mepid 1 ma name op-ma domain op-domain
Switch#

14-9 cfm linktrace

This command is used to issue a link trace message.
cfm linktrace MAC-ADDR mepid MEP-ID ma name MA-NAME domain DOMAIN-NAME [ttl TTL]
[pdu-priority COS-VALUE]
Parameters
MAC-ADDR
mep MEP-ID
name MA-NAME
domain DOMAIN-NAME
ttl TTL
pdu-priority COS-VALUE
Default
None.
Command Mode
EXEC Mode.
Command Default Level
Level: 1.
Usage Guideline
This command is used to issue a CFM link trace message.
Example
This example shows how to transmit an LTM to the destination MAC address 00-01-02-03-04-05.
Switch# cfm linktrace 00-01-02-03-04-05 mepid 1 ma name op-ma1 domain op-domain1
Transaction ID： 26
Specifies the destination MAC address.
Specifies the MEP ID to initiate the link-trace function.
Specifies the MA name as the identifier.
Specifies the MD name as the identifier. It is a string type of maximum
length 22.
Specifies the link-trace message's TTL value. The range is from 2 to
255. The default value is 64.
Specifies the 802.1p priority to be set in the transmitted LBMs. If not
specified, it uses the same priority as the CCMs and LTMs sent by the
MA.
267