Table of Contents
Advertisement
Replacing the Cover and Bezel and Completing the Installation
Replacing the Cover and Bezel and Completing the Installation
To prevent bodily injury when mounting or servicing this unit in a rack, you must take special
Warning
precautions to ensure that the system remains stable. The following guidelines are provided to
ensure your safety:
•
•
•
This unit is intended for installation in restricted access areas. A restricted access area is where
Warning
access can only be gained by service personnel through the use of a special tool, lock and key, or
other means of security, and is controlled by the authority responsible for the location. Statement 37
This equipment must be grounded. Never defeat the ground conductor or operate the equipment in the
Warning
absence of a suitably installed ground conductor. Contact the appropriate electrical inspection
authority or an electrician if you are uncertain that suitable grounding is available. Statement 1024
Warning
When installing or replacing the unit, the ground connection must always be made first and
disconnected last. Statement 1046
To complete your installation, follow these steps:
Install the cover. Place it into position, slide it forward, and then tighten the captive screw (labeled 1 in
Step 1
Figure
Before sliding the cover forward, make sure that the cover will properly engage the ledge at the front of
Caution
the device.
Install the bezel, as follows:
Step 2
a.
b.
Install the device in the rack. See the Cisco Wide Area Application Engine 511 and 611 Hardware
Step 3
Installation Guide for instructions.
Installing Hard Disk Drives in the Cisco Wide Area Application Engine 611
10
This unit should be mounted at the bottom of the rack if it is the only unit in the rack.
When mounting this unit in a partially filled rack, load the rack from the bottom to the top with the heaviest
component at the bottom of the rack.
If the rack is provided with stabilizing devices, install the stabilizers before mounting or servicing the unit in
Statement 1006
the rack.
2).
Align the hooks on the bottom of the bezel with the device.
Press the bezel toward the device until it clicks into place.
78-17404-01
Advertisement
Table of Contents
