Localizing The Spa400 Call Disconnect (Call Processing) Tones - Linksys SPA9000-NA Installation And Configuration Manual

12 . If desired, make a backup copy of the existing
NOTE: You are not overwriting any user message files in this procedure . However, it is a good
practice to make a backup copy of your files before doing any upgrades .
13 . Move the new sounds folder into spa400vm\var\lib on the USB drive . When the
Replace window appears, click Yes to All .
14 . Remove the USB drive from the PC and insert it into the SPA400 .
15 . Power on the SPA400 .
16 . Place a test call to the voice mail system to confirm that the new language prompts are used .

Localizing the SPA400 Call Disconnect (Call Processing) Tones

One important aspect of VoIP-PSTN integration is the Call Disconnect operation . This operation allows
the gateway to detect that the call has been terminated on the other end, so the local line hangs up
automatically . Detecting the tone cadence of the Call Disconnect signal is a trigger for closing the
loop .
Each country has its own Call Disconnect Signal tone which needs to be configured on the SPA400
Tone page .
NOTE:
This feature is available in SPA400 firmware version 1 .0 .1 .4 .
1 . Start Internet Explorer, enter the IP address of the SPA400, and log on .
Tone tab .
2 . Click the
Linksys Voice System Installation and Configuration Guide
Configuring Special Features
sounds folder .
Localization
Confirm Folder
88