Configuring Spa9000 Connectivity With The Spa400 For Pstn And Voice Mail Service - Linksys SPA9000-NA Installation And Configuration Manual

5 . To verify your progress, perform the following tasks:
After the devices reboot, click
–
page . Verify that the line is registered . You may need to refresh the browser screen to see the
new status .
Use an external phone to place an inbound call to the telephone number that was assigned
–
by your ITSP . Assuming that you have left the default settings in place, the Auto Attendant
answers the call . You can then dial an extension number to verify that the call rings to the
station .
NOTE:
If the line is not registered, you may need to refresh the browser several times because
it can take a few seconds for the registration to succeed . If your test call does not go through
to the Auto Attendant, you should review the procedure to verify that you entered the correct
information . Also verify that your DNS is configured properly .

Configuring SPA9000 Connectivity with the SPA400 for PSTN and Voice Mail Service

The SPA400 acts as a gateway to the PSTN and provides an integrated voice mail application . You can
set up your LVS network to use either or both of these services:
PSTN Access (optional if you have internet telephone service):
•
to four standard analog telephones lines to a Linksys Voice System (LVS) VoIP network to provide
access to the Public Switched Telephone Network (PSTN) . The SPA400 sets up and tears down
calls between the PSTN and IP Phones offering seamless telephone service with Linksys VoIP
equipment . To enable this service, you assign a User ID and port on the SPA400, and you configure
the corresponding "Line" settings on the SPA9000 . The LVS network then recognizes the SPA400 as
a service that allows calls to be routed to and from the PSTN .
Voice Mail Service (optional if you have other voice mail service):
•
adapter with an integrated voice mail application for users and extensions that are configured
on the SPA9000 . The integrated voice mail application server supports 32 configurable voice mail
accounts . Although a SPA9000 can be configured with up to four SPA400 devices, only one SPA400
can be configured with the voice mail server .
Important: For optimal voice mail performance, a SPA400 should be dedicated to the voice mail
application when either of the following conditions is met:
1) More than 2 FXO connections are required
— OR —
2) More than 2 users commonly access voice mail at the same time .
In the following procedure, you configure the SPA9000 to register to the SPA400 . If you are using the
SPA400 as a voice mail server, you also enter the settings to subscribe to that service .
NOTE: The first part of this procedure is required whether you are using the SPA400 for either PSTN
access or voice mail . The second part of the procedure is required only if you are using the SPA400 as a
voice mail server .
Linksys Voice System Installation and Configuration Guide
Configuring Phone Service and Voice Mail
Voice tab > Info . Scroll down to the Line 1 Status section of the
Configuring the SPA9000
Each SPA400 can connect up
The SPA400 includes a USB
48