Configuring The Spa400; Configuring The Spa400 Network Connection; Configuring The Voice Mail Server And Voice Mail Users - Linksys SPA9000-NA Installation And Configuration Manual

Configuring the SPA400

If you have a SPA400 in your network, you need to configure the SPA400 to communicate with the
SPA9000 . In addition, if you are using the SPA400 as a voice mail server, you need to configure the
voice mail settings .
"Configuring the SPA400 Network Connection" on page 52
•
"Configuring the SPA400 to Communicate with the SPA9000" on page 53
•
"Configuring the Voice Mail Server and Voice Mail Users" on page 55
•

Configuring the SPA400 Network Connection

The SPA400 becomes a DHCP client of any server on the network . The recommended setting is to use
a static IP address . This configuration provides ease of installation and prevents connectivity issues
that would occur if the IP address of the SPA400 changed .
1 . Start Internet Explorer, and enter the IP address of the SPA400 .
NOTE: By default, the SPA400 is configured to obtain an IP Address via DHCP . You can check the
obtained IP address on the router DHCP server's client list .
2 . When the password prompt appears, enter the default user name,
Then click OK .
NOTE: The user name must be entered exactly as shown: Admin . For information about
managing system access, refer to the LVS Administration Guide .
3 . Click Setup tab > Basic Setup .
4 . Enter the following settings:
Network Setup section:
Fixed IP address:
Click the radio button, and then enter a valid IP address .
–
NOTE:
To avoid addressing conflicts, enter an IP address that is outside the range of addresses
that are automatically assigned by your DHCP server .
IP Subnet Mask: Enter the subnet mask for the subnetwork that the SPA400 is on .
–
Gateway IP Address:
–
Linksys Voice System Installation and Configuration Guide
Configuring Phone Service and Voice Mail
Enter the IP address of the router for this subnetwork .

Configuring the SPA400

Admin, with no password .
52