Busy Lamp Field works only with SPA9x2 series phones, when CTI is enabled . SPA9x1 series
Š
phones do not support CTI .
nme (optional):
Display name for SPA932 key . It may be overwritten with successful
-
SUBSCRIBE .
sub (required):
The station name of the device and the IP address of the SPA9000
-
NOTE:
The station name must exactly match the name that is entered in the phone
configuration web page . The assigned names are displayed on the PBX Status page (click the
PBX Status link on the main administration web page) . For more information about entering a
station name, see
"Setting Up Each Station" on page
ext
(required): The extension number on the specified phone, as in the following example:
-
ext=101@$PROXY . Alternatively, you can enter the usr parameter with the assigned user ID,
as in the following example: usr=Smith@$PROXY .
vid (optional):
Extension ID of the phone lines on the SPA962 (corresponds to Ext 1 to 6; valid
-
values, 1-6)
Submit All Changes .
10 .
Click
11 .
To verify your progress, perform the following tasks:
Verify that the keys on the SPA932 are shining green . A flashing red light indicates a problem
-
with the syntax .
To test a speed dial key, press the key and verify that the destination phone rings .
-
To test a BLF key, place a call from the destination phone and verify that the BLF key flashes
-
red on the SPA932 .
Localization
The prompts, phone display language, and ring tones in LVS can be localized .
•
•
•
•
•
•
•
•
Requirements for Localization
You need TFTP server software to localize the SPA9000 .
Linksys Voice System Installation and Configuration Guide
Configuring Special Features
57 .
Localization
77