Getting To Know Your Spa400 - Linksys SPA9000-NA Installation And Configuration Manual

SPA9000 Back Panel
Port
Phone 1, Phone 2
Ethernet
Internet
Power

Getting to Know Your SPA400

The SPA400 provides the SPA9000 access to the PSTN by connecting the FXO ports to analog lines .
The SPA400 sets up and tears down calls between the PSTN and IP phones, offering seamless
telephone service with Linksys VoIP equipment .
The SPA400 also has a built-in voice mail server .
This section describes the LEDs on the front panel and the ports on the back panel of the device .
SPA400 Front Panel
LED
Power
Status
Ethernet
Linksys Voice System Installation and Configuration Guide
Description/Notes
Use these ports to connect analog phones or fax machines to your IP phone
account .
Use this port to connect a computer for administration of the SPA9000 .
Use this port to connect the SPA9000 to the Local Area Network (LAN) . The
cable may be connected to a switch, router or Integrated Access Device .
Use this port to connect to the external Power adapter (PA100) .
Description/Notes
• Steady green: The SPA400 is receiving power and is connected to the
Internet .
• Flashing: The SPA400 is not connected to the Internet, booting, or
upgrading firmware .
• Steady green: The SPA9000 is registered to the SPA400 .
• Flashing: The SPA9000 is not registered to the SPA400 .
• Steady green: The SPA400 has an active connection through the Ethernet
port .
• Flashing: Network activity is occurring over the Ethernet port .
Getting Started
Introducing LVS Equipment
11