Vpn Firewall Front And Rear Panels - NETGEAR FVX538v2 - ProSafe VPN Firewall Dual WAN Reference Manual

ProSafe VPN Firewall 200 FVX538 Reference Manual

VPN Firewall Front and Rear Panels

The FVX538 front panel shown below contains the port connections, status LEDs, and the factory
defaults reset button.
1 2
Figure 1-1
Table 1-1 describes each item on the front panel and its operation.
Table 1-1. Object Descriptions
Object LED Activity
On (Green)
1.
Power LED
Off
On (Amber)
2.
Blinking (Amber)
Test LED
Off
Two RJ-45 WAN ports N-way automatic speed negotiation, Auto MDI/MDIX.
Link/Act
3,
LED
WAN Ports and
LEDs
100 LED
1-6
3
Description
Power is supplied to the VPN firewall.
Power is not supplied to the VPN firewall.
Test mode: The system is initializing or the initialization
has failed.
Writing to Flash memory (during upgrading or resetting to
defaults).
The system has booted successfully.
On (Green) The WAN port has detected a link with a connected
Ethernet device.
Blinking (Green) Data is being transmitted or received by the WAN port.
Off The WAN port has no link.
On (Green) The WAN port is operating at 100 Mbps.
Off The WAN port is operating at 10 Mbps.
v1.0, January 2010
4 5 6 7
Introduction