Top And Front Panels - NETGEAR R7000 User Manual

Top and Front Panels

The router has status LEDs on top and a USB 3.0 port on the front.
Figure 2. Router top and front view
Table 1. LED and button descriptions
LED Description
Power •
•
•
•
•
Internet •
•
•
•
2.4 GHz
•
Wireless
•
•
5 GHz Wireless •
•
•
USB (1 and 2) The USB 1 LED is for the USB 3.0 USB port on the front panel. The USB 2 LED is for the USB
2.0 port on the rear panel.
•
•
•
Nighthawk AC1900 Smart WiFi Router
Solid amber. The router is starting.
Blinking amber. The firmware is upgrading, or the Reset button was pressed.
Solid white. The router is ready.
Blinking white. The firmware is corrupted.
Off. Power is not supplied to the router.
Solid white. The Internet connection is ready.
Solid amber. The router has detected an Ethernet cable connection to the modem.
Blinking white. The port is sending or receiving traffic.
Off. No Ethernet cable is connected between the router and the modem.
Solid white. The 2.4 GHz WiFi radio is operating.
Blinking white. The router is sending or receiving WiFi traffic.
Off. The 2.4 GHz WiFi radio is off.
Solid white. The 5 GHz WiFi radio is operating.
Blinking white. The router is sending or receiving WiFi traffic.
Off. The 5 GHz WiFi radio is off.
Solid white. A USB device is connected and is ready.
Blinking. A USB device is plugged in and is trying to connect.
Off. No USB device is connected or someone clicked the Safely Remove Hardware
button, and it is now safe to remove the attached USB device.
Hardware Setup
10
USB 3.0 port