NETGEAR FVX538v2 - ProSafe VPN Firewall Dual WAN Reference Manual page 208

ProSafe VPN Firewall 200 FVX538 Reference Manual
Table B-2. IP Addressing Requirements for VPNs in Dual WAN Port Systems
Configuration and WAN IP address
VPN Telecommuter
(client-to-gateway through
a NAT router)
a. All tunnels must be re-established after a rollover using the new WAN IP address.
For the single gateway WAN port case, the mechanism is to use a fully-qualified domain name
(FQDN) when the IP address is dynamic and to use either an FQDN or the IP address itself when
the IP address is fixed. The situation is different when dual gateway WAN ports are used in a
rollover-based system.
• Rollover Case for Dual Gateway WAN Ports
Rollover for the dual gateway WAN port case is different from the single gateway WAN port
case when specifying the IP address of the VPN tunnel end point. Only one WAN port is active
at a time and when it rolls over, the IP address of the active WAN port always changes. Hence,
the use of a fully-qualified domain name is always required, even when the IP address of each
WAN port is fixed.
Note: Once the gateway router WAN port rolls over, the VPN tunnel collapses and
must be re-established using the new WAN IP address.
Figure B-7
• Load Balancing Case for Dual Gateway WAN Ports
B-10
Single WAN Port
(reference case)
Fixed Allowed
(FQDN optional)
Dynamic FQDN required
v1.0, January 2010
Dual WAN Port Cases
Rollover Load Balancing
a
FQDN required Allowed
(FQDN optional)
FQDN required FQDN required
Network Planning for Dual WAN Ports