NETGEAR FVX538v2 - ProSafe VPN Firewall Dual WAN Reference Manual page 23

Table 1-1. Object Descriptions (continued)
Object LED Activity
3,
WAN Ports and Active
LEDs LED
(continued)
8-port RJ-45 10/100 Mbps Fast Ethernet Switch N-way automatic speed negotiation,
auto MDI/MDIX.
Link/Act
LED
4.
LAN Ports and
LEDs
100 LED
DMZ LED
(port 8)
Gbit RJ-45 connector. Port for connecting to a Gigabit Ethernet device.
Link/Act
5. LED
Gigabit Port and
LEDs
Speed
LED
DB9 male connector.
6.
Port for connecting to an optional console terminal. Default baud rate is 115.2K; pinouts:
Console Port
(2) Tx, (3) Rx, (5) and (7) Gnd.
Push in with a sharp object
7.
Factory Defaults reset push button (see
Factory Defaults
Specifications" for the factory defaults).
Introduction
ProSafe VPN Firewall 200 FVX538 Reference Manual
Description
On (Green) The WAN port has a valid Internet connection.
On (Amber) The Internet connection is down or not being used
because the port is available for failover in case the
connection on other WAN port fails.
Off The WAN port is either not enabled or has no link.
On (Green) The LAN port has detected a link with a connected
Ethernet device.
Blinking (Green) Data is being transmitted or received by the LAN port.
Off The LAN port has no link.
On (Green) The LAN port is operating at 100 Mbps.
Off The LAN port is operating at 10 Mbps.
On (Green) Port 8 is operating as a dedicated hardware DMZ port.
Off Port 8 is operating as a normal LAN port.
On (Green) The LAN port has detected a link with a connected
Ethernet device.
Blinking (Green) Data is being transmitted or received by the LAN port.
Off The LAN port has no link.
On (Green) The LAN port is operating at 1,000 Mbps.
On (Amber) The LAN port is operating at 100 Mbps.
Off The LAN port is operating at 10 Mbps.
v1.0, January 2010
Appendix A, "Default Settings and Technical
1-7