Using the VPN Wizard for Client and Gateway Configurations
You use the VPN Wizard to configure multiple gateway or client VPN tunnel policies.
The section below provides wizard and NETGEAR
following scenarios:
•
Using the wizard to configure a VPN tunnel between 2 VPN gateways
•
Using the wizard to configure a VPN tunnel between a VPN gateway and a VPN client
Configuring a VPN tunnel connection requires that all settings and parameters on both sides of the
VPN tunnel match or mirror each other precisely, which can be a daunting task. The VPN Wizard
efficiently guides you through the setup procedure with a series of questions that will determine
the IPsec keys and VPN policies it sets up. The VPN Wizard will also set the parameters for the
network connection: Security Association, traffic selectors, authentication algorithm, and
encryption. The parameters used by the VPN wizard are based on the recommendations of the
VPN Consortium (VPNC), an organization that promotes multi-vendor VPN interoperability.
Tip: When using dual WAN port networks, use the VPN Wizard to configure the basic
parameters and them edit the VPN and IKE Policy screens for the various VPN
scenarios.
Creating Gateway to Gateway VPN Tunnels with the Wizard
Figure 5-3
Follow these steps to set up a gateway VPN tunnel using the VPN Wizard.
1. Select VPN from the main menu and VPN Wizard from the submenu. The VPN Wizard
screen will display. To view the wizard default settings, click the VPN Wizard Default
Values link. You can modify these settings after completing the wizard.
Virtual Private Networking
ProSafe VPN Firewall 200 FVX538 Reference Manual
VPN Client
v1.0, January 2010
configuration procedures for the
5-3