NETGEAR FVX538v2 - ProSafe VPN Firewall Dual WAN Reference Manual page 66

ProSafe VPN Firewall 200 FVX538 Reference Manual
Table 4-2. Outbound Rules (continued)
Item Description
Select Schedule Select the desired time schedule (Schedule1, Schedule2, or Schedule3) that will be used
by this rule.
• This pull-down menu gets activated only when "BLOCK by schedule, otherwise Allow"
or "ALLOW by schedule, otherwise Block" is selected as Action.
• Use schedule screen to configure the time schedules (see
or Allow Specific Traffic" on page
LAN Users These settings determine which computers on your network are affected by this rule.
Select the desired options:
• Any – All PCs and devices on your LAN.
• Single address – Enter the required address and the rule will be applied to that
particular PC.
• Address range – If this option is selected, you must enter the start and finish fields.
• Groups – Select the Group to which this rule will apply. Use the LAN Groups screen
(under Network Configuration) to assign PCs to Groups. See
Hosts (LAN Groups)" on page
WAN Users These settings determine which Internet locations are covered by the rule, based on their
IP address. Select the desired option:
• Any – All Internet IP address are covered by this rule.
• Single address – Enter the required address in the start field.
• Address range – If this option is selected, you must enter the start and end fields.
DMZ Users These settings determine which DMZ computers on the DMZ network are affected by this
rule. Select the desired options.
• Any – All PCs and devices on your DMZ network.
• Single address – Enter the required address and the rule will be applied to that
particular PC on the DMZ network.
• Address range – If this option is selected, you must enter the start and finish fields of
the DMZ computers.
QoS Priority Specifies the priority of a service which, in turn, determines the quality of that service for
the traffic passing through the VPN firewall. By default, the priority shown is that of the
selected service. The user can change it accordingly. If the user does not make a
selection (leaves it as Normal-Service), then the native priority of the service will be
applied to the policy. See
Log This determines whether packets covered by this rule are logged. Select the desired
action:
• Always – always log traffic considered by this rule, whether it matches or not. This is
useful when debugging your rules.
• Never – never log traffic considered by this rule, whether it matches or not.
4-4
4-29).
3-6.
"Specifying Quality of Service (QoS) Priorities" on page
Firewall Protection and Content Filtering
v1.0, January 2010
"Setting a Schedule to Block
"Managing Groups and
4-26.