NETGEAR FVX538v2 - ProSafe VPN Firewall Dual WAN Reference Manual page 56

ProSafe VPN Firewall 200 FVX538 Reference Manual
Note: A separate firewall security profile is provided for the DMZ port that is hardware
independent of the standard firewall security used for the LAN.
The DMZ Setup screen allows you to set up the DMZ port. It permits you to enable or disable the
hardware DMZ port (LAN port 8, see
configure an IP address and Mask for the DMZ port.
To enable and configure the DMZ port:
1. From the main menu, select Network Configuration and then select DMZ Setup from the
submenu. The DMZ Setup screen will display.
2. Check the Do you want to enable DMA Port? radio box.
3. Enter an IP address and the subnet mask for the DMZ port. Make sure that the DMZ port IP
address and LAN Port IP address are in different subnets (for example, an address outside the
LAN Address pool, such as 192.168.1.101).
Figure 3-5
3-12
"VPN Firewall Front and Rear Panels" on page
v1.0, January 2010
1-6) and
LAN Configuration