GE ADTS 542 Instruction Manual page 65

P S
ITOT TATIC
5) - Select the new factor (7) from the list. The new factor is selected and the increment/decrement
factor panel closes.
- Touching the up/down controls (5/6) will increment/decrement the "Rate Aim" value by the new
factor.
6) Touch the "Tick" icon (3), the new value appears in the "Aim" field. The altitude value changes to
the new value, at the rate of change value, and provided that the new value is within acceptable
limits the text will turn green.
7) Touching the "Cross" icon (4), cancels the action and closes the keypad.
: It is possible to change multiple values at the same time by selecting the appropriate aim values
NOTE
(Repeat steps 1 to 4) and then touch the "Tick" item once all changes have been entered. This method
is preferable on the ADTS553/554 products as on a multichannel controller system it is preferable for
all controllers to start at the same time.
- CAS (CAS1, CAS2 on ADTS554)
Displays the currently selected calibrated air speed. To change the value, repeat the same procedure
of - ALT (ALT1, ALT2 on ADTS553/554) for ALT.
- Mach (MACH1, MACH2 on ADTS554)
Displays the current selection. To change the value, repeat the same procedure of - ALT (ALT1, ALT2
on ADTS553/554) for ALT.
63
Figure 3-10: Nudge Increment/Decrement factor selection