Routine Maintenance - GE ADTS 542 Instruction Manual

Routine Maintenance

Absolute cleanliness of the work area, tools and equipment are essential.
Replacing the output connector o-ring
After inspection as detailed in maintenance task B, carry out the following if the o-ring is worn or
damaged:
1) Carefully remove the o-ring from the small groove at the top of the connector. Fit a new o-ring in
the small groove at the top of the connector.
2) Make sure the o-ring is tight in the groove and not damaged after fitting.
: Damage to this o-ring causes leaks.
NOTE
Figure 5-1: Replacing the o-ring
R M
OUTINE AINTENANCE
166