Table of Contents
Advertisement
Pt Only or Ps Only Control modes
This mode can be used as an alternative to test airspeed indicators (ASI) using just the ADTS Pt or Ps
port connected to the ASI. An altitude correction may need entering into the ADTS if there is a height
difference and environmental draughts can cause airspeed errors.
: Enter a positive correction factor when ADTS is below the aircraft reference. Enter a negative
NOTE
correction factor when ADTS is above the aircraft reference
How to use the Pt Only control mode
1)
From Dashboard>> Pitot Static.
2)
On the ADTS Touch, select the Aircraft status icon.
3)
On the Aircraft status screen, tap the "tick" icon to start the Go to ground procedure for all
channels. The ADTS takes all channels to ground pressure.
4)
When the aircraft is at ground, tap the "cross" icon to return to the Pitot Static screen.
5)
Tap Home icon to return to the Dashboard.
6)
From Dashboard >> Settings.
7)
Select ADTS settings.
8)
From the ADTS settings >> CHANNEL MODE.
9)
From the channel mode screen, select "Ps".
10) Select Measure Only. The Ps label changes to Measure Only.
11) Tap Home icon to return to the Dashboard.
12) On the Dashboard screen >> Pitot Static. The Measure screen is displayed.
13) Tap the Control (1) icon to toggle the controller on. The following screen is displayed:
Figure 3-54: Example of Pt Only Control Mode
P
O
P
O
C
T
NLY OR
S
NLY
ONTROL MODES
136
Advertisement
Table of Contents
