GE ADTS 542 Instruction Manual page 171

S
OFTWARE UPDATES
13) Copy these five folders to the root directory of the USB memory stick ready for transfer to the
ADTS Touch.
14) Once the files have been downloaded to the USB memory stick, safely remove the USB memory
stick from the computer.
Installing software updates
Installation of software updates will require you to enter your software upgrade PIN.
Software updates can be installed for both the ADTS and the ADTS Touch via the ADTS Touch. If a
powered base unit is connected to the ADTS Touch over a wired connection, then software updates
can be installed for the ADTS and ADTS Touch. For integrity of the file transfer, the use of the umbilical
cord is recommended.
If the ADTS Touch is only battery powered, then software updates are only possible for the ADTS Touch
and not for the ADTS.
To install software updates for the ADTS and ADTS Touch:
1) Either, position the ADTS Touch on the base unit or connect the ADTS Touch to the base unit
using the umbilical cable.
2) Power-up the ADTS in Standby mode
3) Switch-on the ADTS Touch (1).
4) Insert the USB memory stick into the ADTS Touch USB port (2).
: The USB stick must not be removed once the install process has started.
NOTE
169
Figure 5-2: Software update folders