Preparation
WARNING
•
OBSERVE SAFETY PRECAUTIONS STATED IN LOCAL ORDERS AND THE AIRCRAFT OR EQUIP-
MENT SERVICING PROCEDURES.
CAUTION
•
IT IS THE RESPONSIBILITY OF THE USER TO MAKE SURE THAT THE PNEUMATIC CONTROL
RANGE LIMITS ARE SET BELOW THE MAXIMUM OPERATING LIMITS OF THE EQUIPMENT UNDER
TEST.
Make sure the electrical and pneumatic connectors, electrical cables and pipes and positioning of the
ADTS comply with the instructions and requirements in Section Positioning the ADTS.
CAUTION
•
DO NOT USE SHARP OBJECTS ON THE TOUCH SCREEN. SHARP OBJECTS WILL PERMANENTLY
DAMAGE THE TOUCH SCREEN, IT CANNOT BE REPAIRED.
Carry out the following before use:
1)
If necessary, carry out the maintenance tasks detailed in Section Maintenance Tasks.
2)
Make sure the power at the wall connection point is switched OFF. Connect the ADTS to the elec-
trical power supply at the wall connection point.
MAKE SURE THAT THE SUPPLY INCLUDES A CONNECTION TO A PROTECTIVE EARTH.
: Make sure that the power supply switch can be accessed at all times.
NOTE
P
REPARATION
50