Table of Contents
Advertisement
P
-
OWER
UP ROUTINE
Wireless connection on units using DK0429 software
To establish a wireless connection:
1)
Ensure that the ADTS Touch is not positioned on the docking connector of the ADTS, or
connected to the ADTS using the umbilical cable connector.
2)
Switch the ADTS Touch ON.
3)
From Dashboard >> Tools.
4)
From the Tools menu, select Bluetooth. The Bluetooth sub-menu opens.
5)
Select New scan for devices. Wait while a search for active devices is performed.
6)
Select the required serial number device from the list and touch the "tick" icon. Wait while
connection is established.
If the link has been successful the "Bluetooth® antenna icon" icon is now displayed in the status indi-
cator area of the ADTS Touch, see also ADTS Touch.
Wireless connection on units using DK0467 software
Bluetooth pairing is slightly different on the product using DK0467 software. This has been introduced
to improve product cyber security. To establish a Bluetooth wireless connection:
1)
Pairing must be done when the ADTS controller unit is first powered up. A time period of approx-
imately 5 minutes is allowed to achieve pairing.
2)
Ensure that the ADTS TOUCH is not positioned on the docking connector of the ADTS, or
connected to the ADTS using the umbilical connector.
3)
Apply power to the ADTS Controller, with the unit in STANDBY mode and switch the ADTS
TOUCH ON.
4)
After power up, the Bluetooth LED on the ADTS Controller will be FAST FLASHING. Pairing can
only be achieved whilst the LED is in this state. After approximately 5 minutes the Bluetooth LED
will change to a slower blink.
5)
While the Bluetooth LED is FAST FLASHING :
6)
From Dashboard>> Tools.
7)
From the Tools menu, select Bluetooth. The Bluetooth sub-menu opens.
8)
Select New scan for devices. Wait while a search for active devices is performed.
9)
Select the required serial number device from the list and touch the "tick" icon. Wait while
connection is established.
If the pairing has been successful the "Bluetooth® antenna icon" icon is now displayed in the status
indicator area of the ADTS Touch, and the Bluetooth LED will be SOLID, see also ADTS Touch.
Bluetooth is available in both ON and Standby modes on ADTS553/554 due to the dual handterminal
support requirement.
Wireless operation of the ADTS is now available. See also, section Bluetooth®.
55
Advertisement
Table of Contents
