Removing The Transceiver Module - Cisco 8600 Series Hardware Installation Manual

Removing the Transceiver Module

Procedure
Step 1
Remove the dust plugs from the optical network interface cable MPO connectors and from the transceiver
module optical bores. Save the dust plugs for future use.
Step 2
Attach the network interface cable MPO connectors immediately to the transceiver module.
Figure 67: Cabling a Transceiver Module
Removing the Transceiver Module
Warning
Warning
Hardware Installation Guide for Cisco 8600 Series Routers
80
Statement 1055 Class 1/1M Laser
Invisible laser radiation is present. Do not expose to users of telescopic optics. This applies to Class 1/1M
laser products.
Statement 1051 Laser Radiation
Invisible laser radiation may be emitted from disconnected fibers or connectors. Do not stare into beams or
view directly with optical instruments.
Connect Router to the Network