Table of Contents
Advertisement
Replace Chassis Components
Procedure
Step 1
If you are replacing an SC, open the packaging for the new module and inspect it for damage.
If the SC is damaged, contact your customer service representative and stop this replacement process until
you have an undamaged SC to install.
Step 2
Remove the SC that you are replacing by following these steps:
a) Loosen the captive screws on both sides of the SC. Wait for the Status LED to go in Off state.
b) Rotate the handles outwards until they stop (see Callout 2 in the following figure).
c) Use the ejector handles to pull the module a couple of inches (about 5 cm) out of the slot until it stops.
Note
Figure 74: Remove Switch Card from Chassis
1
Hold the front of the SC with one hand and place your other hand under the SC to support
its weight.
Two captive screws (one on each handle)
2
Rotate both ejector handles to the front of the
module. Pull on both handles to partially remove
the SC from the chassis
Hardware Installation Guide for Cisco 8600 Series Routers
Remove a Switch Card
107
Advertisement
Table of Contents
