Install And Remove Sfp Or Sfp+ Modules - Cisco 8600 Series Hardware Installation Manual

Install and Remove SFP or SFP+ Modules

Caution
The following figure shows the RJ-45 connector.
Figure 58: RJ-45 Connector
1
Install and Remove SFP or SFP+ Modules
Before you remove or install an SFP or SFP+ module, read the installation information in this section.
Warning
Caution
Figure 59: SFP/SFP+ Module Cage Cover
Hardware Installation Guide for Cisco 8600 Series Routers
70
To comply with GR-1089 intrabuilding, lightning immunity requirements, you must use a foil twisted-pair
(FTP) cable that is properly grounded at both ends.
Pin 1
Statement 1051 Laser Radiation
Invisible laser radiation may be emitted from disconnected fibers or connectors. Do not stare into beams or
view directly with optical instruments.
Protect the line card by inserting a clean SFP/SFP+ module cage cover, which is shown in the figure below,
into the optical module cage when there is no SFP or SFP+ module installed.
Connect Router to the Network
2 Pin 8