Transfer Chassis to a Mechanical Lifting Device
Step 2
Attach the bottom-support rail to the rack by using a Phillips torque screwdriver. Use the M6 x 19 mm or
12–24 x 3/4 inch screws for each end of the buttom-support rails and tighten each screw to 40 in-lbs (4.5 N-m)
of torque.
Figure 17: Attach Bottom-Support Rails to Rack
1
2
Note
Step 3
Repeat Steps 1 and 2 to attach the other bottom-support rail to the rack.
Note
What to do next
Transfer chassis to a mechanical lifting device.
Transfer Chassis to a Mechanical Lifting Device
Procedure
Step 1
Place the mechanical lifting device in front of the chassis on the pallet (or on Line Card side) as shown.
Hardware Installation Guide for Cisco 8600 Series Routers
30
Bottom-support rails
M4 x 6-mm Phillips flat-head screws (8)
Use two screws on each end of each bottom-support rail.
Ensure that the two bottom-support rails are level with one another. If they are not level, adjust
the higher rail down to the level of the lower rail.
Unpack and Install the Chassis