Table of Contents
Advertisement
Replace Chassis Components
Reload and boot info
----------------------
RP reloaded Wed May 31 16:03:53 2023: 1 day, 5 hours, 40 minutes ago
Active node booted Wed May 31 16:03:53 2023: 1 day, 5 hours, 40 minutes ago
Standby node boot Wed May 31 16:04:06 2023: 1 day, 5 hours, 40 minutes ago
Standby node last went not ready Wed May 31 16:07:06 2023: 1 day, 5 hours, 37 minutes
ago
Standby node last went ready Wed May 31 16:08:53 2023: 1 day, 5 hours, 35 minutes ago
Standby node last went not NSR-ready Wed May 31 16:06:49 2023: 1 day, 5 hours, 37 minutes
ago
Standby node last went NSR-ready Wed May 31 16:13:26 2023: 1 day, 5 hours, 30 minutes
ago
There have been 0 switch-overs since reload
Active node reload "User initiated chassis reload"
Standby node reload "User initiated chassis reload"
2. To insert the MPA, locate the guide rails inside the chassis that hold the MPA in place.
3. Carefully slide the MPA all the way in the chassis until the MPA is firmly seated in the MPA interface
connector. When fully seated, the MPA might be slightly behind the faceplate.
Note
4. After the MPA is properly seated, pull the ejector lever towards the chassis (marked as 2 in the image).
5. Pull the tab up (marked as 3 in the image).
6. Use a number 2 Phillips screwdriver to tighten the captive screws(marked as 4 in the image) on the MPA.
Figure 73: Install an MPA
The MPA will slide easily into the slot if it is properly aligned on the tracks. If the MPA does not slide easily,
do NOT force it. Remove the MPA and reposition it, paying close attention to engaging it on the tracks. Push
the MPA inside the slot until you hear a click. Continue to push the MPA further until you hear a second click.
The MPA is fully seated only after the second click is heard.
Hardware Installation Guide for Cisco 8600 Series Routers
Install a Modular Port Adapter
103
Advertisement
Table of Contents
