Honeywell ALERTON ACM-VLX Installation And Operation Manual page 48

Installation and Operations Guide
48
|
ACM-VLX/VLX/EXP/AXM
Table 9 PTP s e ttings (Continue d)
Ite m Value
F. Mode m In Enable d Y | N
G. Mode m S pe ake r Y | N
H. Mode m Kbps 38.4
I. PTP Pas s word 1-8 alpha-
nume ric
characte rs
BACnet/IP settings are accessed through item P on the
BACnet/IP settings
Change Configuration menu.
The VLX/ACM-VLX supports Annex J BACnet/IP, which enables BACnet
messages to run over Internet Protocol (IP) Wide Area Networks (WANs). If
your BACnet network runs on an enterprise network connected by IP routers,
you can set up the VLX/ACM-VLX to exchange BACnet data over this network.
BACnet messages are transmitted and received as IP frames.
BACnet/IP settings rely first on correct Ethernet network settings and
connections. See "Ethernet" on page 31 for more information about setting up
Ethernet network parameters.
For more detailed information about BACnet/IP, including architecture
Note
diagrams and different setup scenarios, refer to the BACtalk System Design
Guide (LTBT-TM-SYSDSGN).
Setting up a BACnet system on a network requires knowledge of IP
CAUTION
networking fundamentals. It also requires close coordination with IT and
networking professionals who maintain the network. Seek out contacts in this
field as soon as possible in the project to help you determine appropriate
BACnet/IP settings.
© Honeywell. All Rights Reserved. LT-VLXEXPAXMIOG Rev. 01
Re marks
Enable s /dis able s inbound conne ctions ove r
mode m. S e t to Y to s upport dial-up
conne ctions of a Compas s ope rator
works tation. S e t to N for outbound alarm
dial-out only.
Enable s /dis able s the mode m s pe ake r.
S e t to 38.4.
A cas e -s e ns itive PTP pas s word re s tricting
re mote acce s s to the VLX from a Compas s
ope rator works tation. Whe n you s e t up an
outbound conne ction at the ope rator
works tation, you ne e d to provide this
pas s word. If no pas s word is e nte re d he re ,
acce s s is unre s tricte d. Le ave the pas s word
unas s igne d for mos t othe r type s of PTP
conne ctions .