Honeywell ALERTON ACM-VLX Installation And Operation Manual page 45

Installation and Operations Guide
© Honeywell. All Rights Reserved. LT-VLXEXPAXMIOG Rev. 01
3. Press Y, and then press Enter.
The VLX/ACM-VLX restarts.
4. Close HyperTerminal.
Using the Change Configuration menu
The Change Configuration menu enables you to set network and device
configurations. If necessary, you can make and save changes, disconnect power,
and the VLX will save the setup until the unit is powered up again.
IMPORTANT! Always configure ACM-VLX using Compass Device Manager.
Fig ure 23 The Change Configuration me nu of the VLX Configuration &
Diagnos tic utility
Setting the Device Instance
Configuration menu.
The device instance is a unique number throughout the BACnet internetwork
that identifies the device for BACnet communications. Valid range for the device
instance is 0 to 4,194,303. For more detailed information about device instances,
see the BACtalk System Design Guide (LTBT-TM-SYSDSGN).
Setting Ethernet options
the Change Configuration menu. Select options according to Table 7.
See the BACtalk System Design Guide (LTBT-TM-SYSDSGN) for more
information about Ethernet and IP configurations.
|
Initial firmware and operator workstation setup
The device instance is item A on the Change
Ethernet network settings are items B, C, and D on
45