Honeywell EXCEL5000 OPEN XILON User Manual page 27

Parameters:
Only those parameters which are relevant for the configured application are shown.
Parameters can be changed (see also section "Changing Values" on page 13).
Values which are entered will be changed to align them to a grid of possible values.
If a value is changed, the configuration parameter will be written to the controller. In
some cases, this may cause a reset of the controller.
The following parameters may occur in the parameter list:
RTSnsOffset Room Temp Sensor Offset
C1SnsOffset Condenser 1 Sensor Offset
C2SnsOffset Condenser 2 Sensor Offset
EvAirFlTO Evaporator Air Flow Time Out
LPADelayC1 Alarm delay for compressor 1 low pressure alarm
LPADelayC2 Alarm delay for compressor 2 low pressure alarm
EvFanAct Evaporator fan activation logic
PDownTO1 Pump down time out for cooling compressor 1
VlvPreRun1 Valve 1 pre-run time
PDownTO2 Pump down time out for cooling compressor 2
VlvPreRun2 Valve 2 pre-run time
CutOffClg1 Cooling Cut Off Level 1 (bar or °C)
CutOffHtg1 Heating Cut Off Level 1 (bar or °C)
CutOffClg2 Cooling Cut Off Level 2 (bar or °C)
CutOffHtg3 Heating Cut Off Level 2 (bar or °C)
LeadLag CO Lead / lag change-over time
Dfr Enabl Defrost enabled
Dfr Call Defrost calling time
Dfr Dur Defrost endurance time
Dfr Intrv Defrost time interval
Dfr CStDel Compressor start delay after defrost end
Dfr SDelay Separate or Simultaneous Defrost. 0 means simultaneous defrost
or 1..30 min is the time interval between the two compressors.
Dfr Start Defrost start temperature or pressure (bar or °C)
Dfr End Defrost end temperature or pressure (bar or °C)
ClgSp Occ Temperature set-point occupied (cool)
ClgSp Stdb Temperature set-point stand-by (cool)
HtgSp Occ Temperature set-point occupied (heat)
HtgSp Stdb Temperature set-point stand-by (heat)
Clg PBand Cooling proportional band
Clg Int Cooling integral constant
Htg PBand Heating proportional band
Htg Int Heating integral constant
PI Boost 0=PI Boost off, 1°C = PI Boost functionality enabled
VminSpClg1 Var. speed condenser 1: Min Speed Cooling (bar or °C)
VmaxSpClg1 Var. speed condenser 1: Max Speed Cooling (bar or °C)
VminSpHtg1 Var. speed condenser 1: Min Speed Heating (bar or °C)
VmaxSpHtg1 Var. speed condenser 1: Max Speed Heating (bar or °C)
VminSpClg2 Var. speed condenser 2: Min Speed Cooling (bar or °C)
VmaxSpClg2 Var. speed condenser 2: Max Speed Cooling (bar or °C)
VminSpHtg2 Var. speed condenser 2: Min Speed Heating (bar or °C)
VmaxSpHtg2 Var. speed condenser 2: Max Speed Heating (bar or °C)
27
XILON HANDHELD TOOL - USER GUIDE
EN2B-0214GE51 R0503