Table of Contents
Advertisement
•
from the tree view menu.
The <ESC> key can be used to switch back and forth between the toolbar menu
and the tree view menu.
When the toolbar menu is active, you can switch OFF XILON by going to "device
menu" by pressing the <F10> hot key. To get to the toolbar menu from other
menus, you can use the <ESC> key to go up one level every time the key is
pressed. If the status line displays "F10=Menu", the <F10> hot key can be used to
go immediately to the toolbar menu.
The "power OFF" item is already focused when the device menu screen appears
as shown in the following figure.
< Power OFF
<
Service Pin
< Setup General..>
< Setup Address..>
< SPA interface
NID
:0005127924300
SecCode :Qwzu
F1=Help F10=Menu
Fig. 7. Switching OFF from the toolbar menu
After the <ENTER> key is pressed, a CRC checksum will be calculated and XILON
will then be switched OFF.
If you have switched XILON OFF using this procedure, the CRC checksum will be
used for the next restart to make sure that the data in the battery-buffered RAM
not change while XILON was switched OFF.
It is also possible to switch OFF XILON from the main tree view menu (see Fig. 8).
<ENTER> must be pressed while the item is focused. The <ESC> key can be used
to go to the main tree view menu from lower levels. Every time the <ESC> key is
pressed, you will rise one level in the menu.
Fig. 8. Tree view menu, "Power OFF"
19
XILON HANDHELD TOOL - USER GUIDE
Switching Off from the Toolbar Menu
>
>
>
Switching Off from the Tree view Menu
did
EN2B-0214GE51 R0503
Advertisement
Table of Contents
