NEC UNIVERGE SV9300 Networking Manual page 340

A
CM0B Assign the common port number of Device
Handler Manager (DHM) Self port which is
the communication port between the Main
Unit and Remote Units, if required.
NOTE 1:
Follow the default data setting usu-
ally.
NOTE 2: The DHM self port is the communi-
cation port between Main Unit and
Remote Unit. One port is used to
communicate with one Remote Unit.
With this command, the common
port of DHM self port is specified.
And the following DHM self port is
automatically assigned to each Re-
mote Unit.
Port No. for each Remote Unit
=Common Port (Setting Data) +
Remote Unit No.
And, set the port number that is not
used by other purposes.
Assign the communication mode and the com-
munication speed for the LAN Interface of the
CPU blade in the Remote Unit.
NOTE 1: Assign the communication mode
and the communication speed of the
LAN Interface before you connect to
the Main Unit.
NOTE 2:
Be sure to assign the communication
mode and the communication speed
of the LAN Interface for the CPU
blade in the Main Unit.
END
DESCRIPTION
RESET
RESET
Chapter 3 REMOTE UNIT OVER IP FEATURES
REMOTE UNIT OVER IP VoIPDB DATA ASSIGNMENT
• Y=1XX (VOIP Port [1] + Unit No. [02-50])
(1) 40
(2) 01024-65534: DHM Self Port No. 1024-
NONE
• Y=1XX (VOIP Port [1] + Unit No. [02-50])
(1) 09
(2) 02 : 100 Mbps (Full-Duplex)
03 : 100 Mbps (Half-Duplex)
04 : 10 Mbps (Full-Duplex)
05 : 10 Mbps (Half-Duplex)
15 : Auto Negotiation (GbE)
3-28
DATA
65534
: 3300 [3300-3401 (102 ports
are used)]
NWA-088654-001 Rev.1.0
94ch3001.fm