NEC UNIVERGE SV9300 Networking Manual page 331

• Destination number assigned for ISDN Alternative Routing by CM64 Y=12 as follows.
(a) Destination number setting for each station
– DID number setting is required to each destination station.
– Destination number of each station is assigned by CME6 Y=51. When Mobile Access is
operating in the system, a call terminates to a Mobile phone via C.O. line because this data is
shared with Mobile Access destination number.
– If system data of destination number of each station is not copied to origination station unit,
ISDN Alternative Routing is not performed.
– Virtual station is not appropriate for the destination station.
(b) Destination number setting for each tenant
– DID number setting is required to each tenant of destination station.
– Destination number of each tenant is assigned by CM64 Y=13.
– If system data of destination number of each tenant is not copied to origination station unit,
ISDN Alternative Routing is not performed.
(c) Destination number setting for each tenant and Subaddress
– DID number setting to each tenant of the destination station and called party subaddress setting
to each station as the station number are required. The operation of the trunk of destination
depends on the setting of destination subaddress assigned by CM08>401.
– ISDN network in which called party subaddress is available is required.
– Destination number of each called party subaddress is assigned by CM64 Y=13. Also whether
or not to use the called party subaddress is assigned for each tenant of destination.
– If system data of destination number of each tenant is not copied to origination station unit,
ISDN Alternative Routing is not performed.
Chapter 3 REMOTE UNIT OVER IP FEATURES
3-19
SYSTEM CONDITIONS
NWA-088654-001 Rev.1.0
94ch3001.fm