NEC UNIVERGE SV9300 Networking Manual page 227

To use the dual port mode, do the following programming (the following programming is not required only
when using the single port mode).
START
CM10 Assign the station number connected to
PGD(2)-U10 ADP (CH2) to its associated
Physical Port number.
NOTE:
CM13 For the station connected to PGD(2)-U10
ADP, set the Message Waiting/Stored Call
Record lamps not to be lit.
For the station connected to PGD(2)-U10
ADP, set the call history not to be stored when
answering a station call.
For the station connected to PGD(2)-U10
ADP, set the call history not to be stored when
handling an unanswered station call.
For the station connected to PGD(2)-U10
ADP, set the call history not to be stored when
answering a trunk call.
For the station connected to PGD(2)-U10
ADP, set the call history not to be stored when
handling an unanswered trunk call.
CM12 Assign the kind of PGD(2)-U10 station (CH2).
NOTE:
A
DESCRIPTION
The setting of the Dual port mode is
required when using 2 paging equip-
ment on the PGD(2)-U10 ADP.
For details, refer to "Setting Meth-
od of Port number/Station number
in Dual port mode" in CM10 of the
Command Manual.
When this command is set, PGD(2)-
U10 needs to reset (Blade Reset or
pull out and reconnect the modular
connector of the Multiline Termi-
nal).
• Y=00
(1) XX YY ZZ: Physical Port No.
XX: 01-50: Unit No.
YY: 01-18: Slot No.
ZZ : 17-32: Circuit No.
(2) FX-FXXXXXXXX: Station No.
• Y=03
(1) X-XXXXXXXX: Station No.
(2) 1: Not provided
• Y=41
(1) X-XXXXXXXX: Station No.
(2) 1: Not stored
• Y=49
(1) X-XXXXXXXX: Station No.
(2) 1: Not stored
• Y=60
(1) X-XXXXXXXX: Station No.
(2) 1: Not stored
• Y=61
(1) X-XXXXXXXX: Station No.
(2) 1: Not stored
• Y=65
(1) X-XXXXXXXX: Station No.
(2) 1: Paging
1-213
Chapter 1 CCIS FEATURES
PAGING ACCESS-CCIS
DATA
NWA-088654-001 Rev.1.0
94ch1006.fm