NEC UNIVERGE SV9300 Networking Manual page 254

• For Main Office
COT: When using a COT interface between the Central Office and a Main Office, set up program-
ming to the Main Office by using the DIT-CCIS feature, and send the dial code as an LDN to
the Satellite Office. Refer to programming of DIT-CCIS in this chapter for details.
DID: When using a DID interface between the Central Office and the Main Office, there are two pro-
gramming patterns:
Pattern 1 When an incoming LDN call is diverted to a Satellite Office in both Day Mode and Night
Mode, program by using the LCR and uniform numbering features. Refer to Numbering Plan
Assignment.
Pattern 2 When an incoming LDN call is diverted to a Satellite Office in either Day Mode or Night Mode
(not both), the following programming for the LDN Diversion-Outside feature is required.
START
CM08 Provide the system with the Diversion Display
and the LDN Diversion features.
CM50 Assign the indialed number to each TIE key on
the DESKCON. The indialed number should
be different from any numbers assigned by
CM10 YY=00 and CM11.
CM58 Assign the data for LDN Diversion to each in-
dialed number assigned by CM50 Y=01.
A
DESCRIPTION
TRUNK ANSWER FROM ANY STATION-CCIS
(1) 204: Diversion Display
(2) 0: To provide
(1) 205: LDN Diversion
(2) 0: To provide
• Y=01
(1) 1-8: LDN key No.
(2) X-XXXX: Indialed No.
• Y=00 Tenant No.
(1) 01-08: LDN key 0-7 assigned by CM50
Y=01
(2) 00-63: TAS Group
• Y=02 Day Mode Destination
(1) 01-08: LDN key 0-7 assigned by CM50
Y=01
(2) 09: LDN Diversion-Outside
(Assigned by CM58 Y=08)
1-240
Chapter 1 CCIS FEATURES
DATA
NWA-088654-001 Rev.1.0
94ch1006.fm