Phone Features And Setup Overview; Cisco Ip Phone User Support; Telephony Features For Cisco Ip Phone - Cisco 6800 Series Administration Manual

Phone Features and Setup Overview

•
•
•
•
•
•
•
•
•
•
•
Phone Features and Setup Overview
After you install Cisco IP Phones in your network, configure their network settings, and add them to Third-Party
Call Control System, you must use the Third-Party Call Control System to configure telephony features,
optionally modify phone templates, set up services, and assign users.
You can modify additional settings for the Cisco IP Phone from Third-Party Call Control Configuration Utility.
Use this web-based application to set up phone registration criteria and calling search spaces, to configure
corporate directories and services, and to modify phone button templates, among other tasks.

Cisco IP Phone User Support

If you are a system administrator, you are likely the primary source of information for Cisco IP Phone users
in your network or company. It is important to provide current and thorough information to end users.
To successfully use some of the features on the Cisco IP Phone (including Services and voice message system
options), users must receive information from you or from your network team or must be able to contact you
for assistance. Make sure to provide users with the names of people to contact for assistance and with
instructions for contacting those people.
We recommend that you create a web page on your internal support site that provides end users with important
information about their Cisco IP Phones.
Consider including the following types of information on this site:
• User guides for all Cisco IP Phone models that you support
• List of features supported
• User guide or quick reference for your voicemail system

Telephony Features for Cisco IP Phone

After you add Cisco IP Phones to Third-Party Call Control system, you can add functionality to the phones.
The following table includes a list of supported telephony features, many of which you can configure by using
Third-Party Call Control system.
Cisco IP Phone 6800 Series Multiplatform Phones Administration Guide
148
Configure a Privacy Header, on page 187
Enable P-Early-Media Support, on page 188
Peer Firmware Sharing, on page 188
Profile Authentication, on page 189
Add Ignore Programmable Soft Key to Silence an Incoming Call, on page 190
Enable BroadWorks Anywhere, on page 191
Sync the Block Caller ID Feature with the Phone and the BroadWords XSI Server, on page 191
Enable Viewing BroadWorks XSI Call Logs on a Line , on page 192
DND and Call Forwarding Status Sync, on page 192
Capture Packets, on page 195
Factory Reset the Phone with the Web UI Button, on page 196
Phone Administration