Cisco Ip Phone Installation; Verify The Network Setup - Cisco 6800 Series Administration Manual

Cisco IP Phone Installation

•
•
•
•
•
•
•
•
•
•
•
•
•

Verify the Network Setup

Upon deployment of a new IP telephony system, system administrators and network administrators must
complete several initial configuration tasks to prepare the network for IP telephony service.
For the phone to operate successfully as an endpoint in your network, your network must meet specific
requirements.
Note
The phone displays the date and time from Third-Party Call Control. The time displayed on the phone can
differ from the Third-Party Call Control time by up to 10 seconds.
Procedure
Step 1
Configure a VoIP Network to meet the following requirements:
• VoIP is configured on your Cisco routers and gateways.
• Third-Party Call Control is installed in your network and is configured to handle call processing.
Verify the Network Setup, on page 35
Install the Cisco IP Phone, on page 36
Activation Code Onboarding, on page 37
Configure the Network from the Phone, on page 38
Wi-Fi Settings, on page 45
Verify Phone Startup, on page 56
Configure the Voice Codecs, on page 57
Set the Optional Network Servers, on page 57
VLAN Settings, on page 58
SIP and NAT Configuration, on page 66
Dial Plan, on page 74
Regional Parameters and Supplementary Services, on page 82
Cisco IP Phone 6800 Series Documentation, on page 87
C H A P T E R
Cisco IP Phone 6800 Series Multiplatform Phones Administration Guide
4
35