Emergency Call Support Terminology; Configure A Phone To Make Emergency Calls - Cisco 6800 Series Administration Manual

Multiplatform phones
Hide thumbs Also See for 6800 Series:
Table of Contents

Advertisement

Phone Administration
If all of the location servers do not send a location response, the phone re-sends the location request every
two minutes.

Emergency Call Support Terminology

The following terms describe emergency call support for the Cisco Multiplatform Phones.
• Emergency Location ID Number (ELIN)–A number used to represent one or more phone extensions that
• Emergency Response Location (ERL)–A logical location that groups a set of phone extensions.
• HTTP Enabled Location Delivery (HELD)–An encrypted protocol that obtains the PIDF-LO location
• Location Information Server (LIS)–A server that responds to a SIP-based phone HELD request and
• Emergency Call Service Provider–The company that responds to a phone HELD request with the phone's
• Public Safety Answering Point (PSAP)–Any emergency service (for example, fire, police, or ambulance)
• Universally Unique Identifier (UUID)–A 128-bit number used to uniquely identify a company using

Configure a Phone to Make Emergency Calls

Before you begin
• Obtain the E911 Geolocation Configuration URLs and the company identifier for the phone from your
• Access the phone administration web page. See
Procedure
Step 1
Click the Voice > Ext n, where n is the phone extension number (1-10) of the phone web dialog.
Step 2
In the Dial Plan area, set the Emergency Number to the digits that correspond to the customer emergency
service numbers.
To specify multiple emergency numbers, separate each emergency number with a comma.
Step 3
In the E911 Geolocation Configuration area, set the Company UUID to the unique customer identifier
obtained from your emergency call service provider.
For example:
locate the person who dialed emergency services.
for a phone from a location information server (LIS).
provides the phone location using a HELD XML response.
location. When you make an emergency call (which carries the phone's location), a call server routes the
call to this company The emergency call service provider adds an ELIN and routes the call to the
emergency services (PSAP). If the call is disconnected, the PSAP uses the ELIN to reconnect with the
phone used to make the emergency call.
joined to the Emergency Services IP Network.
emergency call support.
emergency call services provider. You can use the same Geolocation URLs and company identifier for
multiple phone extensions in the same office area.
Access the Phone Web Page, on page
Cisco IP Phone 6800 Series Multiplatform Phones Administration Guide
Emergency Call Support Terminology
92.
185

Advertisement

Table of Contents
loading

This manual is also suitable for:

6821684168516861

Table of Contents