Cisco Nexus 7000 Series Configuration Manual page 98

Configuring PIM Sparse Mode Parameters
Step 14
Step 15
Step 16
Step 17
Cisco Nexus 7000 Series NX-OS Multicast Routing Configuration Guide
84
Command or Action
switch(config-if)# ip pim hello-interval
25000
ip pim border
Example:
switch(config-if)# ip pim border
ip pim neighbor-policy policy-name
Example:
switch(config-if)# ip pim
neighbor-policy my_neighbor_policy
show ip pim interface [interface | brief] [vrf
[vrf-name | all]
Example:
switch(config-if)# show ip pim interface
copy running-config startup-config
Example:
switch(config-if)# copy running-config
startup-config
Configuring PIM and PIM6
Purpose
range is from 1000 to 18724286. The default
is 30000.
Note Before Cisco NX-OS Release
5.2(1), the minimum value was 1
millisecond.
(Optional) Enables the interface to be on the
border of a PIM domain so that no bootstrap,
candidate-RP, or Auto-RP messages are sent
or received on the interface. The default is
disabled.
(Optional) Enables the interface to be on the
border of a PIM domain so that no bootstrap,
candidate-RP, or Auto-RP messages are sent
or received on the interface. The default is
disabled.
(Optional) Configures which PIM neighbors
to become adjacent to based on a route-map
policy with the match ip address command.
The policy name can be up to 63 characters.
The default is to become adjacent with all PIM
neighbors.
We recommend that you should
Note
configure this feature only if you
are an experienced network
administrator.
(Optional) Displays PIM interface information.
(Optional) Saves configuration changes.
(Optional) Configures which PIM neighbors
to become adjacent to based on a route-map
policy with the match ip address command.
The policy name can be up to 63 characters.
The default is to become adjacent with all PIM
neighbors.