Cisco Nexus 7000 Series Configuration Manual page 62

Configuring MLD Interface Parameters
Cisco Nexus 7000 Series NX-OS Multicast Routing Configuration Guide
48
Command or Action
Option
ipv6 mld
last-member-query-count
Example
switch(config-if)# ipv6 mld
last-member-query-count 3
ipv6 mld group-timeout
Example
switch(config-if)# ipv6 mld
group-timeout 300
ipv6 mld
report-link-local-groups
Example
switch(config-if)# ipv6 mld
report-link-local-groups
ipv6 mld report-policy
Example
switch(config-if)# ipv6 mld
report-policy my_report_policy
ipv6 mld access-group
Example
switch(config-if)# ipv6 mld access-group
my_access_policy
Purpose
Description
to 25 seconds. The default
is 1 second.
Sets the number of times
that the software sends an
count
MLD query in response to
a host leave message.
Values can range from 1
to 5. The default is 2.
Sets the group
seconds
membership timeout for
MLDv2. Values can range
from 3 to 65,535 seconds.
The default is 260
seconds.
Enables sending reports
for groups in
224.0.0.0/24. Reports are
always sent for nonlink
local groups. By default,
reports are not sent for
link local groups.
Configures an access
policy
policy for MLD reports
that is based on a
route-map policy.
Configures a route-map
policy
policy to control the
multicast groups that
hosts on the subnet
serviced by an interface
can join.
Configuring MLD