Cisco Nexus 7000 Series Configuration Manual page 44

Configuring IGMP Interface Parameters
Step 4
Step 5
Cisco Nexus 7000 Series NX-OS Multicast Routing Configuration Guide
30
Command or Action
Option
ip igmp immediate-leave
switch(config-if)# ip igmp
immediate-leave
show ip igmp interface [interface] [vrf
vrf-name | all] [brief]
Example:
switch(config)# show ip igmp interface
copy running-config startup-config
Example:
Purpose
Description
Note Only the
match ip
multicast
group
command is
supported in
this route map
policy. The
match ip
address
command for
matching an
ACL is not
supported.
Enables the device to
remove the group entry
from the multicast routing
table immediately upon
receiving a leave message
for the group. Use this
command to minimize the
leave latency of IGMPv2
group memberships on a
given IGMP interface
because the device does
not send group-specific
queries. The default is
disabled.
Note Use this
command only
when there is
one receiver
behind the
interface for a
given group.
(Optional) Displays IGMP information about
the interface.
(Optional) Saves configuration changes.
Configuring IGMP