Default Settings - Cisco Nexus 7000 Series Configuration Manual

Configuring PIM and PIM6
• Multicast works on periodic joins/prune and depending on the topology and number of routers in the
• The

Default Settings

Table 12: Default PIM and PIM6 Parameters
Parameters
Use shared trees only
Flush routes on restart
Log Neighbor changes
Auto-RP message action
BSR message action
SSM multicast group range or policy
PIM sparse mode
Designated router priority
Hello authentication mode
Domain border
RP address policy
PIM register message policy
BSR candidate RP policy
BSR policy
Auto-RP mapping agent policy
Auto-RP RP candidate policy
Join-prune policy
Neighbor adjacency policy
BFD
network, S,G state takes time to expire.
must be enabled by using the ip pim sparse-mode command on loopback interfaces
sprase-mode
that are configured as PIM rendezvous points.
Default
Disabled
Disabled
Disabled
Disabled
Disabled
232.0.0.0/8 for IPv4 and FF3x::/96 for IPv6
Disabled
0
Disabled
Disabled
No message filtering
No message filtering
No message filtering
No message filtering
No message filtering
No message filtering
No message filtering
Become adjacent with all PIM neighbors
Disabled
Cisco Nexus 7000 Series NX-OS Multicast Routing Configuration Guide
Default Settings
77